|
| |
 |
CB-1A
Assembled Circuit Board: |
 |
 |
Description:
CB-1A is our basic camera system circuit
board that is already assembled.
It is 2" x 3" in size. It was designed to allow the
do-it-yourselfer to assemble their own game camera system allowing a them a very affordable,
high quality game camera system. All of the components are installed and
the circuit board is tested before it is shipped. Check out the design
features below!
|
Works
Great With The Cannon Owl PF Camera!
|
|
Click Here to view a sample completed game camera
using the CB-1
|
Click Here to view a some
pictures taken using the Canon Owl PF and CB-1
|
Click Here to see an explanation of how to setup
the CB-1 board
|
|
This kit is not recommended for people who are not familiar with
soldering electronic components!
Want to
buy it assembled?
|
|
Order an LCD counter module
also!
After purchasing the CB-1A, all you have to do is:
- Solder the supplied electronic components on the board using the very easy
to understand instructions.
- Connect the 6VDC battery holder (batteries and battery holder not included)
leads to the
circuit board.
- Modify your camera (not included) and connect to the inhibit switch, then
connect to the board
Then you are ready to go!
If you want a more robust game camera system, you can purchase the optional event
counter and connect it to the circuit board. The points are
already there on the circuit board if you want to add it later!
|
This
Product has been discontinued! We are going to make this an
"open source" project soon.
|
|
|
Design
Features: |
|
- Low Power consumption for long battery life.
- Idle current draw: 200µA typical
- Timing Cycle current draw: 450µA typical
- LED current draw: 6mA typical
- Two different sensor mounting options.
- Adjustable camera shutter output (2 to 13 Seconds).
- Adjustable motion sensor sensitivity with a range of 60+ feet.
- Counter output for the optional event
counter.
- Bright LED walk test light.
- 4 time delay Options before next picture is allowed to be taken.
- 30 seconds, 1 Minute, 3 Minutes, 5 Minutes
- Custom delay times available, contact us
- 6 to 10 VDC battery operation (4-C cell batteries Recommended, they should last all season long!)
|
|
What's
Included With the Assembled Board: |
|
-
All electronic components including the PIR and fresnel
lens.
-
Power switch and camera inhibit switch (What's
the inhibit switch for?).
-
Diagrams that show where to connect the batteries,
camera, and event counter.
-
Easy to follow instructions including a detailed
component placement diagram.
-
Circuit board mounting template for easy mounting to
enclosure.
-
Nylon standoffs, with mounting screws.
-
Panel mount walk test LED.
|
|
What's
NOT Included With the Assembled
Board: |
|
- Event counter (Can't find one? Click Here!).
- Event counter reset switch.
- Event counter connector/socket
- Circuit board connectors/sockets
- Battery holder or batteries.
- Enclosure.
- Wiring.
- Camera.
|
| |
|
